The versatile waterborne finish. Waterborne 1-Component finish for wooden floors. For heavy wear. Used on millions of m2 in offices and homes, this finish offers a variety of uses. Elastic, good chemical and abrasion resistance. Simple and safe application Used in millions of homes and offices Range of use: Suitable for parquet and hardwood floors. Application: The surface must be sanded properly, wood moisture content max. 12%. The floor must be dry and free from any old coatings, oil, grease, wax, silicone, sanding dust and other contaminants. Room temperature +15C to +25C, relative humidity 40% to 75%, material temperature +18C to +25C. Ensure working areas are adequately ventilated. Transfer material to a LOBATOOL varnish bucket before applying. Shake the contents well. Observe the general and, if available, the product-specific health and safety instructions. More specific information relating to GISCODE can be found in the usage instructions, which are available on the "Documents" tab above. Thinner: The product is supplied ready for use and must not be diluted! Application tool/application rate: LOBATOOL roller Deluxe 120 / 100-120 ml(g)/m = 8-10m/l(kg) LOBATOOL roller Microfaser 100-120 / 80-100 ml(g)/m = 10-12m/l(kg) Intermediate sanding: Able to recoat without intermediate sanding within the first 24 hours. After this time, an intermediate sanding is necessary. An intermediate sanding before the last application will achieve an even finish. Use LOBATOOL perforated pad P120 or finer, alternatively Sanding Net P120 or finer. Carefully remove dust before overcoating. Drying time Earliest possible recoating after 4-6 hours. Careful use possible after 4-6 hours. Earliest possible intermediate sanding after 8-10 hours. Light use after 24 hours. Full use and covering possible after 5 days. The floor can be covered earlier by using LOBATOOL Cover 400, for details see the TI for the product. We recommend using a primer: to minimise side bonding and to seal off wood constituents, e.g. in exotic timber. WS EasyPrime. OptiPrime. PrimaSeal Plus (contains solvent). Use on parquet and hardwood floors: Prepare and prime the substrate properly. Allow the primer to dry as specified. Apply by roller. Dry. Intermediate sanding. Apply second coating layer by roller.
Brand
- Loba
